Clinton Electronics VF540 Bedienerhandbuch PDF herunterladen (Seite 10)

Installation

1. Bracket & Camera Mounting

- Ax the bracket to the mounting surface.

- Run cables through the center of the mounting bracket, or out the side slot.

2. Power Connector & Monitor Impedance

- Use a DC12V/1A regulated PSU or AC24V/1A.

- To avoid re or shock hazards, always use a CE marked PSU.

- Set the monitor impedance switch to 75Ω. Check the impedance switch if

the screen is blurred.

3. Viewing Angle & Focus Adjustment

- To widen the viewing angle, loosen set screw and rotate the Zoom Lever to

the Left; rotate to the Right to narrow the viewing angle. Tighten set screw

when done adjusting.

- To adjust focus, loosen set screw, and rotate the Focus Lever Left or Right to

obtain proper focus. Tighten set screw when done adjusting.

4. Sunshield Mounting

- After completing view & focus adjustments, clip the sunshield into place.

5. Remote control & VBS Extra

- Remove the cap and connect the connector of the remote control and VBS

Extra to the cable socket.

Sales: 1-800-447-3306 Support: 1-800-549-6393 www.clintonelectronics.com

mounting screws

mounting plate

camera arm screws

Remote port

zoom

focus

Sunshield

cable routing:

center or side

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Keine Kommentare

Clinton Electronics VF540 Bedienerhandbuch Seite 10